Linux version 2.4.3-20mdk (chmou@no.mandrakesoft.com) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release / Linux-Mandrake 8.0)) #1 Sun Apr 15 23:03:10 CEST 2001
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f400 (usable)
 BIOS-e820: 000000000009f400 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000e9400 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000007ff0000 (usable)
 BIOS-e820: 0000000007ff0000 - 0000000007fffc00 (ACPI data)
 BIOS-e820: 0000000007fffc00 - 0000000008000000 (ACPI NVS)
 BIOS-e820: 00000000fffe9400 - 0000000100000000 (reserved)
On node 0 totalpages: 32752
zone(0): 4096 pages.
zone(1): 28656 pages.
zone(2): 0 pages.
Kernel command line: BOOT_IMAGE=linux ro root=306 quiet
Initializing CPU#0
Detected 851.948 MHz processor.
Console: colour dummy device 80x25
Calibrating delay loop... 1697.38 BogoMIPS
Memory: 126168k/131008k available (976k kernel code, 4452k reserved, 287k data, 696k init, 0k highmem)
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
VFS: Diskquotas version dquot_6.5.0 initialized
CPU: Before vendor init, caps: 0387f9ff 00000000 00000000, vendor = 0
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 256K
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: After vendor init, caps: 0387f9ff 00000000 00000000 00000000
CPU serial number disabled.
CPU: After generic, caps: 0383f9ff 00000000 00000000 00000000
CPU: Common caps: 0383f9ff 00000000 00000000 00000000
CPU: Intel Pentium III (Coppermine) stepping 06
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: Intel
PCI: PCI BIOS revision 2.10 entry at 0xfd9a6, last bus=1
PCI: Using configuration type 1
PCI: Probing PCI hardware
Unknown bridge resource 0: assuming transparent
Unknown bridge resource 2: assuming transparent
PCI: Using IRQ router PIIX [8086/7110] at 00:07.0
PCI: Found IRQ 9 for device 00:0a.0
PCI: The same IRQ used for device 01:00.0
  got res[10000000:10000fff] for resource 0 of Ricoh Co Ltd RL5c476 II
  got res[10001000:10001fff] for resource 0 of Ricoh Co Ltd RL5c476 II (#2)
Limiting direct PCI/PCI transfers.
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.14)
Starting kswapd v1.8
vesafb: framebuffer at 0xf0000000, mapped to 0xc8800000, size 8192k
vesafb: mode is 800x600x16, linelength=1600, pages=7
vesafb: protected mode interface info at c000:8886
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
Console: switching to colour frame buffer device 100x37
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
block: queued sectors max/low 83757kB/27919kB, 256 slots per queue
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: chipset revision 1
PIIX4: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0xfcd0-0xfcd7, BIOS settings: hda:pio, hdb:DMA
hda: IBM-DJSA-220, ATA DISK drive
hdb: TOSHIBA DVD-ROM SD-C2502, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 39070080 sectors (20004 MB) w/1874KiB Cache, CHS=2584/240/63, UDMA(33)
hdb: ATAPI 24X DVD-ROM drive, 128kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
Partition check:
 hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 hda10 hda11 >
Serial driver version 5.05 (2000-12-13) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md.c: sizeof(mdp_super_t) = 4096
autodetecting RAID arrays
autorun ...
... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 696k freed
Adding Swap: 521600k swap-space (priority -1)
MSDOS FS: Using codepage 850
MSDOS FS: IO charset iso8859-1
8139too Fast Ethernet driver 0.9.15c loaded
PCI: Found IRQ 9 for device 00:08.0
PCI: The same IRQ used for device 00:07.2
eth0: RealTek RTL8139 Fast Ethernet at 0xc9060c00, 00:e0:18:0f:b3:d7, IRQ 9
eth0:  Identified 8139 chip type 'RTL-8139C'
eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
maestro3: version 1.22 built at 23:13:19 Apr 15 2001
PCI: Found IRQ 10 for device 00:06.0
PCI: The same IRQ used for device 00:06.1
maestro3: Configuring ESS Allegro found at IO 0xF800 IRQ 10
maestro3:  subvendor id: 0x10491043
ac97_codec: AC97 Audio codec, id: 0x4583:0x8308 (ESS Allegro ES1988)
Winbond Super-IO detection, now testing ports 3F0,370,250,4E,2E ...
SMSC Super-IO detection, now testing Ports 2F0, 370 ...
parport0: PC-style at 0x378 [PCSPP,TRISTATE]
parport0: cpp_daisy: aa5500ff(18)
parport0: assign_addrs: aa5500ff(18)
parport0: cpp_daisy: aa5500ff(18)
parport0: assign_addrs: aa5500ff(18)
lp0: using parport0 (polling).
inserting floppy driver for 2.4.3-20mdk
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306