*** MP3LCDTSR (MLT) for MpxPlay by Fab (2000)
*** Get the last Version at www.multimania.com/screamers/mlt
*** Version 2.05

What is MLT ?
-------------

MLT is a simple TSR (Terminate-but/and-Stay-Resident) CardWare.
This Soft is able to grab information directly from the screen
produced by mpxplay to a 16x2 parallel input LCD.
By using the mlt.ini, you can set up everything on your display,
where you want.
Actually, the aim of this is to be put in a car.

if you like this program, just send me an email ! 
fab : screamers@multimania.com

Where should I get mpxplay ?
----------------------------

MpxPlay is available at www.geocities.com/mpxplay (Free)


How to build the LCD Connection ?
---------------------------------

In order to realise this you need a male DB25, some wire and an LCD display.
The LCD I used for my own experimentation is a ACM-1602AT(S)L.
But anyway you can use the one you want as soon as it go a parallel input.
(About 14 or 16 pin on the LCD Bus)

I put here the pin number of the parallel port to help you.
(see from the side you will connect your wire )
   -----------------------------------
 /  14 15 16 17 18 19 20 21 22 23 24 25 \
/  1  2  3  4  5  6  7  8  9 10 11 12 13 \
 ------------------------------------------

Pin connection:

LPT Pin:           LCD Pin :
                     Make sure that the LCD is at the ground, and
                     have a good power supply (see the doc of your own
                     LCD)
2                    DB0 ( DB for Data Bus Line )
3                    DB1
4                    DB2
5                    DB3
6                    DB4
7                    DB5
8                    DB6
9                    DB7
1                    D1 ( enable signal )
                     Data Read&Write ---> Ground
17                   RS : Register Select Signal
16                   E2 ( Enable signal )
GND(On Metal         GND
    of connector)

Note that if you are using a LCD of only 2 lines, you will not have
the E2 enable signal. This pin is used only to select the group of 2 line you
wish to use : in fact the HD4448 works like that : for any LCD, One HD4448 leads
2 lines. So in 40x4 LCD there is 2 HD4448, and they are independent.

Note that all your ground must be connected together...

Features
--------

Please Report to mlt.ini file.

FAQ
---

Please report to the forum on the official web site : www.multimania.com/screamers/mlt

----------------------------------------- EOF